Press and hold the PROGRAM button until both LED lights turn BLUE.Program the keypad for a single doorOn the power head: Wireless Keypad ( Model OKP-BX) with CodeDodger ® Program Keypad for One Garage Door (CodeDodger 2) Create Your Wireless Keypad PIN (Personal Identification Number) On your wireless keypad: Mark the bottom hole, then screw in the bottom screw.Īdditional AssistanceShould you need additional information about installing or programming your garage door opener or remote, please call customer service at 1-80, or use our distributor locator to find a Red Ribbon Distributor near you.Install a screw into the top drilled hole, leaving a 1/8" gap between the screw head and the wall.Drill a 1/16" hole for the top mounting screw.If the red LED does not blink during use, the battery needs to be changed.After a few seconds, the LED will turn off, and you can retry. Rapid blinking of the LED indicates an error.Any keypad button will control the door for 30 seconds after the door starts moving.If the LED blinks rapidly, the PIN was entered incorrectly.If the garage door does not move, check the red LED on the keypad.Each door opener must be programmed to receive the signal from the wireless keypad. Repeat steps one through five for programming each garage door opener.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |